Mesh inflation layer not shown - Project Support - SimScale CAE Forum
$ 14.50 · 4.7 (697) · In stock
Hi all, I am currently trying to inflate boundary layer of 1st layer < 1e-5. When I try to make the inflation layer smaller, the layer did not grow. I tried using both relative and absolute size and also played with the advance options. Can you give me some feedback on what I did wrong? From the mesh log, I can see that the inflation layer is as intended and after “Selecting externalDisplacementMeshMover displacementMedialAxis” there is some iteration that causes the layer not to grow. This
Inflation does not follow edge of airfoil
JMSE, Free Full-Text
794 questions with answers in MESH
7 Questions to Ask CAE Vendors of Structural Analysis and Simulation Software
Your Guide to Meshing Techniques for Efficient CFD Modeling
7 Questions to Ask CAE Vendors of Structural Analysis and Simulation Software
Mechanical Ventilation Simulation and Optimization with SAV Systems, by SimScale
Resources, Free Full-Text
SimScale - Another Fine Mesh
Inflation does not follow edge of airfoil
Week 3 - External flow simulation over an Ahmed body.