Print failure - became spongy and stringy mid-print – How do I

I was printing a 73mm high model yesterday. The first 25mm went fine, but then the print became "spongy" and "stringy" as if not enough filament was b

3D Printing Troubleshooting: All Problems & Solutions

Failed 3D Prints, and How to Fix Them : 6 Steps (with Pictures) - Instructables

Failed 3D Prints, and How to Fix Them : 6 Steps (with Pictures) - Instructables

Printing Guidance】The Influence of Filament Dryness and Humidity on Printing Effect

filament - Why is my print getting messed up mid-print? - 3D Printing Stack Exchange

How to Troubleshoot Stringy Prints on Your 3D Printer

3D Printer Issues and How to Troubleshoot them

Failed 3D Prints, and How to Fix Them : 6 Steps (with Pictures) - Instructables

First layer problem with loose strings – Assembly and first prints troubleshooting – Prusa3D Forum

3D Printer Stringing: How To Fix It