Black spots on brass ammo and clip - General Ammunition Discussion

$ 7.99 · 4.5 (303) · In stock

So I bought this ammo about a month ago, and have seen black spots appearing on it ever since. Finally, I decided that I should get advice about this. Here are some details: The ammo is made out of brass, and so is the stripper clip The ammo and brass is fit for the Arisaka 99. The ammo is 7.7x58. These were made in the 1940s They’ve been out in the open most often Here is a picture These are not hair, I can’t rub them off. But if you can answer, it would be greatly appreciated.

Overpressure ammunition - Wikipedia

Bulk 9mm Ammo In Stock - 124 gr FMJ - 9 mm Luger Ammunition by

Tarnished Factory Ammo - SASS Wire - SASS Wire Forum

03.jpg

243 vs 270 Review & Comparison

Reading Pressure Signs

Opinions on what's going on with this brass

10mm Vs 45 10mm vs 45 acp Side-by-Side Comparison [2022]

Federal 7 mm 150 Grain Mag Bullets

Ammunition problems: How to detect, prevent, and avoid them

Questions about colt revolver

What Are The Basic Parts of Ammunition? - The Components of Ammo

MCX 5.56 excessive markings on brass